Composition

• Methacrylates
• Fluoride
• Barium glass
• Amorphous silica

• 2 × 5 ml ParaCore Dentin SLOW
• 2 × 5 ml ParaCore Trans SLOW
• 3 × 3 ml ParaBond Non-Rinse
• Conditioner + Adhesive A & B
• 20 × Mixing Tip Short Super Fine

Tooth Isolation:

• Ensure a dry working field for optimal results.
• It is recommended to use a rubber dam (e.g., Waldent Rubber Dam Kit of 21 (K16/2)) to isolate the tooth.

Post Cementation:

• Select a suitable endodontic post system 

Applying ParaBond Non-Rinse Conditioner:

• Dispense Non-Rinse Conditioner from the ParaCore Slow Intro Kit into the mixing well.
• Apply Non-Rinse Conditioner into the prepared post space and onto the contact surfaces (preparation/cavity) using a brush. Massage for 30 seconds.
• Remove excess Non-Rinse Conditioner from the root canal using paper points.
• Dry the contact surfaces (preparation/cavity) using a gentle stream of air for 2 seconds.

Applying ParaBond Adhesive:

• Mix one drop of Adhesive A from the ParaCore Slow Intro Kit together with one drop of Adhesive B into the mixing well.
• Apply the mixed adhesive components into the prepared post space and onto the contact surfaces (preparation/cavity) using a brush. Massage for 30 seconds.
• Remove excess adhesive from the root canal using paper points.
• Dry the adhesive bond layer using a gentle stream of air for 2 seconds.

Using ParaCore Slow Intro Kit to Cement Posts:

• Remove the syringe plug or used the mixing tip.
• Extrude a small amount of ParaCore material from the ParaCore Slow Intro Kit directly out of the syringe onto a paper towel/tissue until equal amounts of base and catalyst are being extruded.
• Wipe off excess material from the orifice.
• Attach the mixing tip from the ParaCore Slow Intro Kit and twist clockwise (90 degrees) to lock it in place.
• Dispense ParaCore directly from the syringe into the prepared root canal using the Root Canal Tip.
• Coat the root canal post completely with the mixed ParaCore material.
• Insert the post into the root canal using gentle pressure.
• Remove excess ParaCore material using appropriate instrumentation.
• Disinfect the mixing tip from the ParaCore Slow Intro Kit after each use and do not remove it.
• Prepare the core build-up as soon as the ParaCore material has completely cured.

Core Build-Ups: Applying ParaBond Non-Rinse Conditioner:

• Dispense the Non-Rinse Conditioner into the mixing well.
• Apply the Non-Rinse Conditioner onto the entire preparation/cavity using a brush. Massage for 30 seconds.
• Dry excess Non-Rinse Conditioner using a gentle stream of air for 2 seconds.

Applying ParaBond Adhesive:

• Mix one drop of Adhesive A with one drop of Adhesive B in the mixing well.
• Apply the mixed adhesive components onto the contact surfaces (preparation/cavity) using a brush. Massage for 30 seconds.
• Dry the adhesive bond layer using a gentle stream of air for 2 seconds.

Application of ParaCore:

• Remove the syringe plug or used mixing tip and extrude a small amount of ParaCore material onto a paper towel/tissue until equal amounts of base and catalyst are being extruded.
• Wipe off excess material from the orifice with a paper towel/tissue and attach the mixing tip by twisting it clockwise to lock it in place.
• Apply ParaCore directly to the preparation